Dell Emulex Family of Adapters - Manual (Page 1222)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
iSCSI Port
1222
2. In the Emulex Device Management tree-view, select the FC port for which you want
to change the driver parameters.
3. Select the Driver Parameters tab.
4. Click Export to create and save a desired port parameter configuration. Each
definition is saved in a comma-delimited file with the following format:
=
5. Click Apply to apply your configuration changes.
Enabling/Disabling PFC Throttle on an FCoE Port
To enable or disable PFC throttle:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.
2. In the Emulex Device Management tree-view, select the FCoE port whose PFC
throttle status you want to change.
3. Select the Port Details tab (Figure 6-2 on page 54).
4. In the PFC Throttle area, select Enable or Disable. PFC throttle is immediately
enabled or disabled, depending upon your selection.
Note: The Enable/Disable button is disabled for OCe11100–series adapters and the
LPe16202 CFA.
Configuring FIP Parameters for an FCoE Adapter
The FIP tab enables you to configure FIP for FCoE adapters.
To configure FIP parameters for an FCoE port:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.
2. In the Emulex Device Management tree-view, select the FCoE port for which you
want to configure FIP information.
3. Select the FIP tab (Figure 6-16 on page 71).
4. Set the parameters you want and click Apply Changes.
iSCSI Port
Viewing iSCSI Port Information
When you select an iSCSI port from the Emulex Device Management tree-view, the
iSCSI Port Information tab shows general attributes associated with the selected iSCSI
port.
To view general iSCSI port information:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.