Dell Emulex Family of Adapters - Manual (Page 1240)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
iSCSI Port
1240

Sync'd – If yes, the FCoE priority has been set by the peer. This parameter
cannot be set.

Error – The iSCSI error state. This capability indicates whether an error has
occurred during the configuration exchange with the peer.
ETS Priority Group Properties Area
Note: Not shown when UMC is enabled on the adapter.

State – The current Priority Group state. It can be Enabled or Disabled.

Sync'd – If yes, the Priority Groups have been set by the peer. This parameter
cannot be set.

Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer.
Active Groups

PG –The Priority Group number. It can be 0 to 7.

Priorities – The priorities that are assigned to each Priority Group. It is
represented in comma separated format.

Bandwidth % – The percentage of available link bandwidth allocated to a
particular Priority Group.
DCB Tab Buttons

Configure DCB –Click to configure DCB parameters. See the instructions that
follow.
To configure DCB for iSCSI adapter ports:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.
2. In the Emulex Device Management tree-view, select the FCoE adapter port whose
FIP properties you want to configure.
3. Select the DCB tab.
4. Click Configure DCB. The Configure DCB dialog box appears.
5. Configure the settings you want and click OK.