Dell Emulex Family of Adapters - Manual (Page 1612)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
10. Configuring and Managing iSCSI Targets with the iSCSISelect Utility
Adding iSCSI Targets
1612
iSCSI Boot Configuration” on page 1596.
Note: You must enable the Boot Target option after you add the target via
SendTargets (see step 16).
10. Change the ISID qualifier value, if necessary. A unique ISID value is necessary if
you connect dual sessions to the same target portal group. Enter a number up to
65535. For more information, see “Setting an ISID Value” on page 1616.
11. Select Yes from the Header Digest pop-up menu if you want to enable header
digest. When set to Yes, and the iSCSI initiator is set accordingly, the integrity of an
iSCSI PDU’s header segment is protected by CRC32C checksum. The default setting
is No.
12. Select Yes from the Data Digest pop-up menu if you want to enable Data Digest.
When set to Yes, and the iSCSI initiator is set accordingly, the integrity of an iSCSI
PDU’s data segment is protected by CRC32C checksum. The default setting is No.
13. Select an authentication method (optional). If you are enabling an authentication
method, you are prompted to enter CHAP configuration. For more information, see
“Enabling CHAP Authentication” on page 1616.
14. Select Save/Login. A message reminds you that you have left the iSCSI Target name
blank and that the SendTargets mechanism will be used. If you want to continue,
press .
15. If the firmware successfully logs into the target, the Targets Discovered Via
SendTargets screen appears. An unsuccessful login produces a failure message.
After you send your SendTargets request to the target, the Targets Discovered Via
SendTargets screen appears with a list of targets. From this list of targets specify
which targets to add.
To do this, select the target or targets you want to add from the menu and press
. After you have selected your targets, you can add these targets to the list of
iSCSI targets available for the initiator to login. To do this, select Add Selected
iSCSI Targets and press (Figure 10-3). If you enabled CHAP
Authentication, you are prompted to enter CHAP configuration for each target, one
at a time.For more information, see “Enabling CHAP Authentication” on page 1616.
Figure 10-3 Targets Discovered via SendTargets Screen