Dell Emulex Family of Adapters - Manual (Page 187)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
NIC
187
PFC Properties Area

State – Enabled means that flow control in both directions (Tx and Rx) is
enabled. State – Enabled means that flow control in both directions (Tx and Rx)
is enabled. Disabled means that priority-flow control is currently disabled. The
priority value, if Shown, is not applicable. This may be caused by:

The switch port priority-flow control being set to On instead of Auto

Switch port using port flow control instead of priority flow control

PFC disabled at adapter or switch

Active Priorities – Lists the priorities with PFC set to enabled.

Sync’d – If yes, the PFC priorities have been set by the peer. This parameter
cannot be set.

Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer or when the compatible
method for the capability fails.
NIC Properties Area

State – The NIC state. It can be enabled or disabled.

Active Priority – The current active priority assigned for NIC.

Sync’d – If yes, the NIC priority has been set by the peer. This parameter cannot
be set.

Error – The NIC error state. This capability indicates whether an error has
occurred during the configuration exchange with the peer.
ETS Priority Group Properties Area
Note: Not displayed when multichannel is enabled on the adapter with the exception
of NPar.

State – The current Priority Group state. It can be enabled or disabled.

Sync’d – If yes, the Priority Groups have been set by the peer. This parameter
cannot be set.

Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer.
Active Groups

PG – The Priority Group number. It can be 0 to 7.

Priorities – The priorities that are assigned to each Priority Group. It is
represented in comma separated format.

Bandwidth % – The percentage of available link bandwidth allocated to a
particular Priority Group.

Max Configurable PGs – This field indicates maximum number of priority
groups that can be configured on the selected adapter port.
DCB Tab Buttons