Link discovery events (0200 - 0299) – Dell Emulex Family of Adapters User Manual
Page 1044
Emulex Drivers Version 10.2 for VMware ESXi User Manual
P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1044
Link Discovery Events (0200 - 0299)
elx_mes0200: CONFIG_LINK bad hba state
DESCRIPTION: A CONFIG_LINK mailbox command completed and the driver was
not in the right state.
DATA: None
ACTION: Software driver error. If this issue persists, report these errors to Emulex
technical support.
elx_mes0203: Devloss timeout on WWPN N_Port
DESCRIPTION: A remote N_Port that was discovered by the driver disappeared for
more than lpfc_devloss_tmo seconds.
DATA: (1) nlp_flag, (2) nlp_state, (3) nlp_rpi
ACTION: If the device generating this message is not a target to which the adapter is
connected, this error does not affect the data integrity of the I/O between the adapter
and the attached storage and can be ignored.
elx_mes0206: Device discovery completion error
DESCRIPTION: This indicates that an uncorrectable error was encountered during
device (re)discovery after a link up. FC devices are not accessible if this message is
displayed.
DATA: None
ACTION: Reboot the system. If the issue persists, report the error to Emulex technical
support. Run with verbose mode on for more details.
elx_mes0207: Device
Ignoring device.
DESCRIPTION: Invalid service parameters were received from DID. Ignoring this
remote port.
DATA: DID, WWN
ACTION: Verify the remote port's configuration. If the issue persists, report the error to
Emulex technical support. Run with verbose mode on for more details.
elx_mes0222: Initial FLOGI/FDISK timeout
DESCRIPTION: The driver sent the initial FLOGI or FDISK to the fabric and never got a
response back.
DATA: None
ACTION: Check Fabric configuration. The driver recovers from this and continues with
device discovery.