Dell Emulex Family of Adapters - Manual (Page 1546)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
3. Configuring PXE Boot for NIC on OCe14000-series Adapters
Using the PXESelect Utility
1546
Physically Identifying the Port
To physically determine which port you are configuring by causing the link and
activity LEDs of that port to blink:
1. On the Port Configuration screen, press .
2. The LEDs on your controller begin blinking. The selected port’s LED status
indicators blink on your controller for approximately 15 seconds.
Note: Not all controllers have LEDs that are visible externally. If you are using an
add-in card in a blade server environment, the port identification or beaconing
capability does not work.
Erasing Ports and Controller Configuration
Note: When this setting is selected, all previous configuration settings are returned to
their factory default settings except for the current personality selection. Emulex
recommends performing this action to provide a clean environment for new
configuration settings to take effect.
To erase the ports and controller configuration:
1. On the Configure Controller screen (Figure 3-3), press to restore the factory
default settings. A warning appears asking if you want to erase the current
configuration for all ports of the controller.
2. Press to delete the configuration. You will receive another warning asking you
to confirm the permanent removal of the controller configuration.
3. Press to delete the configuration.
To exit the PXESelect utility after erasing the ports and controller configuration:
1. Follow the instructions on the bottom of the individual menu screens until you are
prompted to exit.
2. Press to exit. Depending on the settings that were changed, a reboot may be
necessary.
Note: For older systems, depending on the memory allocation method supported,
the PXESelect utility automatically reboots even when there are no changes
made to the system.