Dell Emulex Family of Adapters - Manual (Page 1653)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1653
Switch Independent Mode Multichannel Configuration
To configure the multichannel configuration when the Multichannel Mode is set to
Switch Independent Mode:
1. On the Emulex NIC Selection screen, select Controller Configuration and press
. A list of available options is displayed.
Figure 11-21 Switch Independent Mode Controller Configuration Screen
2. From the Controller Configuration screen, you can perform the following tasks:

View the current configuration of each function – see “Viewing the
Configuration” on page 1646.

Configure the minimum and maximum bandwidth percentage – see
“Configuring Minimum and Maximum Bandwidth” on page 1647.

Configure the LPVID per function – see “Configuring the LPVID” on page 1648.
Note: An LPVID is required for every function when using Switch
Independent Mode, but it is optional for IBM Virtual Fabric Mode and
IBM Unified Fabric Protocol Mode.

Save the current configuration – see “Saving the Configuration” on page 1649.