Dell Emulex Family of Adapters - Manual (Page 1231)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
iSCSI Port
1231
Initiator Default Login Options Window Field Definitions

InitialR2T – The initial request to transmit. When set to Yes, the initiator has to
wait for the target to solicit SCSI data before sending it. When set to No, it
allows the initiator to send a burst of unsolicited FirstBurstLength bytes.

ImmediateData – If set to Yes, allows the initiator to append unsolicited data to
a command.

MaxOutstandingR2T – The maximum number of outstanding request to
transmit's (R2T's) per task within a session, each up to MaxBurstLength bytes.

FirstBurstLength – The maximum amount of unsolicited data (in bytes) the
initiator can send to the target during the execution of a single iSCSI command.

MaxBurstLength – The maximum amount of either unsolicited or solicited data
the initiator may send in a single burst. Any amount of data exceeding this
value must be explicitly solicited by the target.

DefaultTimeToWait – The minimum time to wait, in seconds, before the
initiator attempts to reconnect or reassign a connection (or task) that has been
dropped after an unexpected connection termination or reset. The initiator and
target negotiate to determine this value.

DefaultTimeTo Retain – The maximum time, in seconds, to reassign a
connection after the initial wait that is indicated in DefaultTime2Wait has
elapsed. The initiator and target negotiate to determine this value.

HeaderDigest – The valid values for this property are CRC32C or None. If set to
CRC32C and the initiator is configured accordingly, the integrity of an iSCSI
PDU's header segments is protected by a CRC32C checksum.

DataDigest – The valid values for this property are CRC32C or None. If set to
CRC32C and the initiator is configured accordingly, the integrity of an iSCSI
PDU's data segment is protected by a CRC32C checksum.

MaxConnections – The maximum number of connections to targets that are
allowed within a single session.

DataPPDUInOrder – The order of data PDUs within a sequence.

DataSequenceInOrder – The order between sequences.

MaxRecDataSegmentLength – The maximum data segment length in bytes an
initiator or target can receive in an iSCSI PDU.

ErrorRecoveryLevel – The operational ErrorRecoveryLevel for the session. 0
indicates recovery only by session restart. 1 indicates recovery by reissuing
commands, data, or status. 2 indicates connection failure recovery.
Initiator Default Login Options Window Buttons

Close – Click to close the window.