Dell Emulex Family of Adapters - Manual (Page 121)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
121

Ex Count Orig – The number of FC exchanges originating on this port. (Not
supported on VMware ESXi servers being managed through the CIM interface.)

Active XRIs – The number of active exchange resource indicators. (Not
supported on VMware based ESXi platforms using the CIM interface.)

Received P_BSY – The number of FC port-busy link response frames received.

Link Transitions – The number of times the SLI port sent a link attention
condition.

Elastic Buf Overruns – The number of times the link interface has had its elastic
buffer overrun.

Rx Frames – The number of FC frames received by this adapter port.

Rx Words – The number of FC words received by this adapter port.

Rx KB Count – The received kilobyte count by this adapter port.

Rx Sequences – The number of FC sequences received by this adapter port. (Not
supported on VMware ESXi servers being managed through the CIM interface.)

NOS count – The number of NOS events that have occurred on the switched
fabric. (Not currently supported for Emulex Windows drivers or arbitrated
loop.)

Dumped Frames – The number of frames that were lost due to a lack of host
buffers available. (Not currently supported for the SCSIport Miniport driver,
the Storport Miniport driver or the driver for Solaris.)

Loss of Sync – The number of times loss of synchronization has occurred.

Prim Seq Prot Errs – The primitive sequence protocol error count. This counter
is incremented whenever there is any type of protocol error.

Invalid CRCs – The number of frames received that contain CRC failures.

Ex Count Resp – The number of FC exchange responses made by this port. (Not
supported on VMware ESXi servers being managed through the CIM interface.)

Active RPIs – The number of remote port indicators. (Not supported on
VMware ESXi servers being managed through the CIM interface.)

Receive F_BSY – The number of FC port-busy link response frames received.

Primitive Seq Timeouts – The number of times a primitive sequence event timed
out. (Not supported on VMware ESXi servers being managed through the CIM
interface.)

Arbitration Timeouts – The number of times the arbitration loop has timed out.
Large counts could indicate a malfunction somewhere in the loop or heavy
usage of the loop. (Not supported on VMware ESXi servers being managed
through the CIM interface.)
If you selected a COMSTAR port, the following information is also displayed:
Note: COMSTAR ports are supported on OpenSolaris only.

SCSI Write I/O Count – The number of SCSI write I/O requests received.

SCSI Write KB Count – The total number of kilobytes written.

Total SCSI I/O Count – The number of SCSI I/O requests received.