Dell Emulex Family of Adapters - Manual (Page 1671)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
12. Configuring UEFI for iSCSI
Configuring the Network
1671
Configuring an IPV4 Address
To configure an IPv4 address:
1. On the Network Configuration screen (Figure 12-6), ensure the IP version is set to
IPV4 or DUAL MODE.
2. Select Configure IPV4 Address and press . The Configure IPV4 Address
screen is displayed.
Figure 12-8 Configure IPV4 Address Screen
3. From the Configure IPV4 Address screen, you can do the following:

Enable DHCP for automatic assignment of the IP address through a DHCP
server. See “Automatically Assigning an IP Address through a DHCP Server”
on page 1671 for more information.

Configure a static IP address (when Initiator IP via DHCP is disabled). See
“Manually Assigning an IP Address” on page 1672 for more information.

Ping the iSCSI initiator. See “Pinging the iSCSI Initiator” on page 1672 for more
information.
Automatically Assigning an IP Address through a DHCP Server
To enable DHCP for automatic assignment of the IP address through a DHCP server:
1. On the Configure IPV4 Address screen (Figure 12-8), select Initiator IP via DHCP
and press .
2. From the Initiator IP via DHCP pop-up menu, select Enable and press .
3. Select Save DHCP Settings and press .