Dell Emulex Family of Adapters - Manual (Page 1586)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
6. Using the FCoE Boot BIOS Utility for x86 and x64 Architectures
Configuring Advanced Adapter Parameters
1586
2. Select Change Default ALPA of this adapter and press . Information
similar to Figure 6-14 is displayed.
Figure 6-14 Change Default ALPA Screen
3. Change the default AL_PA, use the up and down arrow keys to scroll through the
valid AL_PAs. Table 6-1 lists the valid AL_PA values.
4. Press to accept the new value.
5. Press to return to the advanced adapter configuration menu.
6. For changes to take effect, reboot the system.
Note: If the adapter's AL_PA is changed, it does not show on the NVRAM AL_PA
until the system has been reset.
Table 6-1 Valid AL_PA Values
0x00 0x01 0x02 0x04 0x08 0x0F 0x10 0x17
0x18 0x1B 0x1D 0x1E 0x1F 0x23 0x25 0x26
0x27 0x29 0x2A 0x2B 0x2C 0x2D 0x2E 0x31
0x32 0x33 0x34 0x35 0x36 0x39 0x3A 0x3C
0x43 0x45 0x46 0x47 0x49 0x4A 0x4B 0x4C
0x4D 0x4E 0x51 0x52 0x53 0x54 0x55 0x56
0x59 0x5A 0x5C 0x63 0x65 0x66 0x67 0x69
0x6A 0x6B 0x6C 0x6D 0x6E 0x71 0x72 0x73
0x74 0x75 0x76 0x79 0x7A 0x7C 0x80 0x81
0x82 0x84 0x88 0x8F 0x90 0x97 0x98 0x9B
0x9D 0x9E 0x9F 0xA3 0xA5 0xA6 0xA7 0xA9
0xAA 0xAB 0xAC 0xAD 0xAE 0xB1 0xB2 0xB3
0xB4 0xB5 0xB6 0xB9 0xBA 0xBC 0xC3 0xC5
0xC6 0xC7 0xC9 0xCA 0xCB 0xCC 0xCD 0xCE
0xD1 0xD2 0xD3 0xD4 0xD5 0xD6 0xD9 0xDA
0xDC 0xE0 0xE1 0xE2 0xE4 0xE8 0xEF