Dell Emulex Family of Adapters - Manual (Page 465)

Offline and Online Adapter Management Utilities Version 10.2 User Manual P010071-01A Rev. A
2. Installation
Offline Adapter Management Utility Installation for FreeBSD
465
In Windows, for example, three directories should be visible in the kit's root directory
after you extract the standalone utility. The top level “boot” directory and “firmware”
directory are the default directories in which elxflash looks for firmware and boot code
images. Ensure that firmware and boot code are located in these directories.
# dir
07/05/2012 07:02 PM
07/05/2012 07:02 PM
07/02/2012 03:14 PM
07/02/2012 03:14 PM
07/02/2012 03:15 PM
The Offline Adapter Standalone Management utility has the same dependencies as the
offline utility. See “Platform Prerequisites” on page 459.
Note: There are no update or uninstall procedures for the Offline Adapter Standalone
Management utility. When a new version is available, you extract it, replacing
the older version.
Offline Adapter Management Utility Installation for
FreeBSD
The Offline Adapter Management Utility installation for FreeBSD uses an install script.
The install script determines the correct architecture and distribution and performs the
following operations:

Installs the ElxflashOffline utility and linlpcfg

Temporarily mounts /proc
Note: For security reasons, /proc is not mounted by default; however, Elxflash and
linlpcfg require that /proc be mounted in order to run. Verify /proc is mounted
before running Elxflash or linlpcfg.
To install the Offline Adapter Management utility for FreeBSD:
1. Untar the installation tarball.
2. Run the install script located in the root directory of the installation kit.
For example:
# tar xvf elxflashOffline---.tgz
# cd elxflashOffline---
# ./install.sh
Updating
To update the Offline Adapter Management utility for FreeBSD, uninstall the old
version and then unzip the new version.