Dell Emulex Family of Adapters - Manual (Page 443)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
UMC Commands
443
UmcSetLPVID
Note: This command has been replaced by the CMSetLPVID command and is
provided for backward compatibility for OCe11100-series adapters only.
This command sets the LPVID values for the UMC and SIMode NIC channels. Use the
UmcGetParams command to determine the number of LPVIDs required. See
“UmcGetParams” on page 440 for more information.
A reboot is not required for these changes take effect when UMC is enabled
Note: When the current multichannel mode is not UMC or SIMode, the UmcSetLPVID
command fails.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
UmcSetLPVID ... [LPVIDn]
Parameters
Considerations for Using UmvSetLPVID

LPVID values are in the range of 2-4094.

Every NIC channel on a physical port must have a unique LPVID.

For FCoE and iSCSI channels, ‘0’ must be entered because LPVIDs can only be
specified for NIC channels.

LPVIDs specified for channels with protocols set to "None” are ignored.

This command is not supported on 1 Gb ports.

If channel management is disabled when this command is executed, an error
message is displayed.
Examples
All NIC Channels
>hbacmd UmcSetLPVID 00-00-c9-12-34-56 1001 1002 1003 1004
Storage on 2nd channel
>hbacmd UmcSetLPVID 00-00-c9-12-34-56 1001 0 1002 1003
WWPN
WWPN of an FCoE function on the physical adapter port.
MAC
MAC address of any NIC or iSCSI function on the physical adapter
port.
LPVID0
LPVID for channel 0.
LPVID1
LPVID for channel 1.
LPVIDn
LPVID for channel n.