Dell Emulex Family of Adapters - Manual (Page 64)

OneCommand™ Manager Application P010066-01A Rev. A
2. Installing and Uninstalling OneCommand Manager Application Components
Installing the OneCommand Manager Application
64
The following are the possible achange values:
0 – Do not allow Management Mode to change
1 – Allow Management Mode to change
You can also set the following optional parameters:

MHost – This optional switch allows a non-management-host user to select
a Management Host with which to register. If this switch is not specified, the
default value of 0 is used and the capability is disabled. If the switch is
specified, the value can be a host name or an IP address which is validated
by the installer. An error message appears if /mmode is set as Local Only or
Management Host.

excl – This optional switch allows the non-management-host user to select
whether the OneCommand Manager application processes requests
exclusively from the Management Host specified by the MHost switch. This
option is only accepted if accompanied by a valid MHost value; otherwise
an error message appears. If this switch is not specified, the default value of
0 is used. If the switch is specified, the valid values are:
0 – Remotely managed by other hosts.
1 – Remotely managed by Management Host ONLY.

Mtcp – This optional switch allows you to enable or disable remote
management and to specify the TCP/IP port number over which
management occurs. If this switch is not specified, the default TCP/IP port
number 2333 is used.
If the management host option is selected, you must either select the default
port number or enter a valid TCP/IP port number on the command line. A
value of 0 is not accepted.
If one of the non-management host options is selected, you can enter the
TCP/IP port number on the command line.
In Linux
Note: The OneCommand Manager application GUI is not supported on Citrix
XenServer. Refer to the OneCommand Manager application CLI User Manual
for Citrix instructions.
The following must be installed before you can install the OneCommand Manager
application:

The appropriate driver for your operating system:

Linux driver version 8.2.0.33.3p or later (for RHEL 5 operating systems).

Linux driver version 8.3.5.X or later (for RHEL 6 and SLES 11 SP1 operating
systems).
Note: The RHEL 6 Enterprise kit requires the installation of the
libstdc++-5.so library. This library is available through the
compat-libstdc++-33-3.2.3-68..rpm or later. The PPC and
x86_64 builds require the 64-bit version, which is installed in