Dell Emulex Family of Adapters - Manual (Page 149)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
149

From the Port menu, click Reset Port.

From the toolbar, click Reset.
The following warning appears:
Figure 8-25 Reset Warning
3. Click Yes. The adapter port resets.
The reset can require several seconds to complete. While the adapter port is
resetting, the status bar shows “Reset in progress.” When the reset is finished, the
status bar shows “Reset Completed”.
Configuring FC/FCoE Driver Parameters
The OneCommand Manager application displays available driver parameters along
with their defaults and maximum and minimum settings. A description of the selected
parameter is also provided. This section contains information you should be aware of
when working with driver parameters. For a more detailed description of specific
driver parameters, refer to the appropriate Emulex driver User Manual. (Not available
in read-only mode.)
Note: This section only applies to FC and FCoE drivers. It does not apply to NIC,
RoCE, and iSCSI drivers.
Note: In Solaris and Linux, you can also specify parameters when loading the driver
manually. (Not available in read-only mode.) Refer to the appropriate driver
manual for instructions.
Activation Requirements
A parameter has one of the following activation requirements:

Dynamic – The change takes effect while the system is running.

Reset – Requires an adapter reset from the utility before the change takes effect.

Reboot – Requires reboot of the entire machine before the change takes effect. In
this case, you are prompted to perform a reboot when you exit the utility.