Dell Emulex Family of Adapters - Manual (Page 1791)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix H. Configuring PXE Boot for NIC on Dell OCe14000-based Systems
Running the PXESelect Utility
1791
Appendix H. Configuring PXE Boot for NIC on
Dell OCe14000-based Systems
This section describes how to use the PXESelect utility to set up a PXE bootable
network by configuring your Dell OCe14000-based controllers.
Note: For Dell adapter models D6T93, F6PCP, JJPC0, and P3V42, PXE boot can be
performed only on the first NIC partition on each port in the legacy x86 BIOS.
Note: For Dell OCe10100-based adapters, see appendix G., “Configuring PXE Boot for
NIC on Dell OCe10100-based Systems,” on page 1784.
For more information on the PXE protocol, the PXE Boot process, and remotely
installing with PXE on different operating systems, see chapter 3., “Configuring PXE
Boot for NIC on OCe14000-series Adapters,” on page 1534.
Running the PXESelect Utility
To run the PXESelect utility, start or restart your computer. When prompted, hold
down and press
. If you are running the PXESelect utility with multiple
controllers, all your controllers are displayed when you start the utility. For example:
Press
for PXESelect(TM)Utility
Controller#0 Port#0 Base 0xFCE60000 at Bus:05 Dev:00 Fun:00
Controller#0 Port#1 Base 0xFCEA0000 at Bus:05 Dev:00 Fun:01
Controller#1 Port#0 Base 0xFC920000 at Bus:01 Dev:00 Fun:00
Controller#1 Port#1 Base 0xFC960000 at Bus:01 Dev:00 Fun:01
- Initializing ...Done.
The PXE Configuration menu appears after the boot BIOS initializes to begin your PXE
configuration.
Note: A UEFI-capable system typically does not display the prompt for running the
PXESelect utility unless it is configured for legacy booting. See your system
configuration manual for information on performing a legacy boot. All
configuration that can be performed in the PXESelect utility can instead be
performed in the UEFI configuration utility. See appendix F., “Dell UEFI,” on
page 1762 for more information.
Navigating the PXESelect Utility
Use the following methods to navigate the PXESelect utility:

Press the up or down arrows on your keyboard to move through and select
menu options or configuration fields. When multiple adapters are listed, use the
up/down arrows to scroll to the additional adapters.