Dell Emulex Family of Adapters - Manual (Page 1718)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
14. Troubleshooting
Troubleshooting for the FCoE Protocol
1718
Troubleshooting for the FCoE Protocol
You receive any of the following
POST error messages or warnings:
Redboot Initialization
failed...
Firmware Load failed...
DDR config failed...
DDR callibrate failed...
DDR test failed...
SEEPROM checksum failed...
Secondary firmware image
loaded...
These POST messages indicate that you must reload the adapter
firmware using OneCommand Manager or one of the Emulex
online or offline utilities. If the errors persist, contact Technical
Support.
You receive this POST error
message:
Firmware halted. This
firmware does not support
this controller.
The firmware loaded on this adapter is not supported. Load the
appropriate firmware for the controller.
Table 14-2 Troubleshooting the iSCSISelect Utility (Continued)
Issue Answer/Solution
Table 14-3 Troubleshooting the FCoE Protocol
Issue Answer/Solution
Cisco Nexus switch configuration
situations:
• Windows creates the NTFS
partition properly, but then
reports that “The hard disk
containing the partition or free
space you chose has a LUN
greater than 0. Setup cannot
continue”. (Dell 1850 server).
• Windows reboots successfully,
but then gets stuck during the
GUI portion of the installation
right from the beginning. (HP
DL385G2 server).
Ensure that the FCoE switch ports are configured correctly for the
adapter’s FCoE settings.