Dell Emulex Family of Adapters - Manual (Page 365)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Dump Commands
365
Example
To enable dynamic target mode:
hbacmd SetDriverParam 10:00:00:00:c9:ff:ff:ff L P enable-dtm 1
To disable dynamic target mode, set the flag to 0.
SetDriverParamDefaults
This command changes all values to the default for the adapter(s).
Supported By
Linux, VMware ESXi, and Windows
Syntax
SetDriverParamDefaults
Parameters
Dump Commands
The diagnostic dump feature enables you to create a “dump” file for a selected adapter.
Dump files contain information such as firmware version, driver version, and
operating system information. This information is useful when troubleshooting an
adapter, but is unavailable in read-only mode.
Caution: Disruption of service can occur if a diagnostic dump is run during I/O
activity.
The dump files created are text files (“.txt” extension) and binary files. The extension
for binary files depends on the adapter type:

OneConnect and LPe16202 adapters (Enhanced FAT Dump) – “.edf” extension

OneConnect adapters (Core Dump) – “.core” extension

LPe16000-series adapters (except LPe160202) – “.bin” extension

LPe12000 and LPe11000-series adapters – “.dmp” extension
WWPN
The WWPN of an FC or FCoE port.
Flag1
L = Make change local for this adapter only.
G = Make change global (applies to all adapters on this host).
Flag2
P = Make change permanent (the change persists across reboot).
T = Make change temporary.