Dell Emulex Family of Adapters - Manual (Page 92)

OneCommand™ Manager Application P010066-01A Rev. A
5. Configuring Discovery
Discovery Using the TCP/IP Access Protocol
92
Adding a Range of Hosts (IPv4 Only)
You can find the TCP/IP-accessed manageable hosts by searching a range of IPv4
addresses. The Add Range of TCP/IP Hosts dialog box enables you to build the initial
list of TCP/IP accessed manageable hosts. (Not available in strictly local or local plus
management modes.)
Note: The following notes apply when adding a range of hosts:

The ranges of IP addresses are only scanned each time you open the Add
Remote TCP/IP Hosts dialog box and click Start Discovery. The ranges are
not automatically scanned by the discovery server during its discovery
cycles.

Discovery of VMware (CIM) hosts is only supported on Windows systems.

Adding a range of hosts is only supported for IPv4 addresses. It is not
supported for IPv6 addresses.

The OneCommand Manager application must be installed on all remote
hosts.
Figure 5-4 Add Range of TCP/IP Hosts Dialog Box
To add a range of remote hosts:
1. From the Discovery menu, select TCP/IP>Add Range of Hosts. The Add Range of
TCP/IP Hosts dialog box appears.