Dell Emulex Family of Adapters - Manual (Page 129)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
129
Maintenance Tab Field Definitions
Firmware Area

Firmware Version on Flash – The firmware version stored on the adapter’s
non-volatile storage. When the system restarts, this version becomes the active
firmware version.

Service Processor FW Version – The firmware version that is currently
operational on the adapter.

Active Firmware Version – The version of firmware running on the selected
adapter.

ULP FW Name – The firmware version running on the (Upper Layer Protocol)
processors within the ASIC.
WWN Management Area
Note: COMSTAR ports are supported on Solaris 11 only.
Current

WWPN – The World Wide Port Name for the selected adapter port.

WWNN – The World Wide Node Name for the selected adapter port.
Pending Changes

WWPN – Works in conjunction with the Change WWN button. Displays the
World Wide Port Name you assigned for the selected adapter port, but the
system must be rebooted for these changes to take effect and appear under the
“Current” listing. See “Configuring Boot from an FC SAN” on page 254 for
more information.

WWNN – Works in conjunction with the Change WWN button. Displays the
World Wide Node Name you assigned for the selected adapter port, but the
system must be rebooted for these changes to take effect and appear under the
“Current” listing. See “Configuring Boot from an FC SAN” on page 254 for
more information.
Maintenance Tab Buttons (Not available in read-only mode.)

Configure Boot – Click Configure Boot to configure boot from SAN. See
“Configuring Boot from an FC SAN” on page 254 for more information. (Not
available on VMware ESXi servers being managed through the CIM interface.)

Change WWN – Click to change the selected adapter port's World Wide Node
Name or World Wide Port Name.
Viewing FC/FCoE Target Information
When you select a target associated with an FC/FCoE adapter from the discovery-tree,
the Target Information tab displays information associated with that target.
To view FC/FCoE target information:
1. Select Host, Fabric or Virtual Port view.