Dell Emulex Family of Adapters - Manual (Page 801)

OneCommand NIC Teaming and VLAN Manager User Manual P009415-01A Rev. A
5. OneCommand NIC Teaming Manager Command Line Interface
The Command Reference
801
Parameters
Description
This command adds a specified adapter from the specified team. The adapter can only
be added if the team currently has less than the maximum number of adapters for that
team type. For more information about adding an adapter, see “Replacing a Team
Adapter” on page 770.
Example
c:\Program Files\Emulex\NIC Teaming>OcTeamCmd.exe add adapter myteam nic14
Adapter nic14 has been successfully added to team myteam
Setting an Adapter as Primary
The following command lets you set an adapter as primary.
Note: The primary adapter must be an Emulex-branded adapter.
Note: You cannot set an adapter as primary if it is not a member of the team.
Syntax
# OCTeamCmd.exe set primary
Example
c:\Program Files\Emulex\NIC Teaming>octeamcmd.exe set primary myteam nic5
Adapter nic6 has been successfully set as primary adapter for the team myteam
Removing an Adapter from a Team
Note: Do not remove an adapter while it is carrying traffic. If you do, unpredictable
results will occur.
Note: Adapters that have been disabled in either Network Connections or device
Manager cannot be managed by the OneCommand NIC Teaming and VLAN
Manager and may not be visible to the OneCommand NIC Teaming and VLAN
Manager. Make sure that any affected adapters are enabled before making any
NIC Teaming configuration changes.
Syntax
delete adapter
team-id
Team from which an adapter is to be added.
adapter-id
Adapter to be added.