Dell Emulex Family of Adapters - Manual (Page 960)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
960
Pause param set failed
The firmware command to set pause frame settings
failed. Warning
POST timeout; stage=
The power-on self test of the adapter failed. This is
an indication of a hardware or firmware issue. Try
rebooting the system after a reset. Error
queue_setup failed
Firmware command failed to create requested
number of queues. Error
Re-Enabling HW multicast
filtering
Disabling HW multicast
filtering
Exhausted multicast HW
filters
This is an information log about a change in
multicast filtering in the adapter. Information
Set Tx Rate on VF
failed
Firmware command failed to change transmission
rate as requested. Error
Setting HW VLAN filtering
failed
Adding a VLAN filter to HW failed. Error
tx rate must be between 100
and Mbps
Request to change transmission rate was issued
with an invalid TX rate value. Request failed and
speed will not be changed. Error
txq: cleaning pending
tx-wrbs
The driver did not get completions for some
transmit requests from the adapter while unloading
the driver. This usually indicates an issue with the
adapter. Error
UFI and Interface are not
compatible for flashing
Requested UFI image is not compatible with the
chip on which the flash was requested. Error
Unrecoverable Error detected
in the adapter
Please reboot server to
recover
UE LOW: bit set
UE HIGH: bit set
There is an unrecoverable error detected in the
adapter that requires a reboot to recover. Low and
high bits set in the data path in which error
occurred. Error
Using profile
An informational message of profile type currently
enabled in the adapter. Information
VFs are assigned to VMs: not
disabling VFs
Do not disable virtual functions on the port during
driver unload, on which VFs are assigned to guests
which are powered ON. Warning
VLAN config on VF
failed
Firmware command failed to set VLAN filter as
requested. Error
Waiting for FW to be ready
after EEH reset
After a PCI EEH reset, wait until firmware becomes
ready. Information
Table 4-5 Ethernet Driver Log Messages of Type (Continued)
Ethernet Log Message Description Type