Dell Emulex Family of Adapters - Manual (Page 509)

Offline and Online Adapter Management Utilities Version 10.2 User Manual P010071-01A Rev. A
4. Offline Adapter Management Utility Command Line Interface
Using Script Files
509
In the following script file example, messages from the version and listhba commands
are output to the log file and to the screen. After the screendisplay command is set to 0,
all successive commands (download, listboot, and enableboot) result messages are
output only to the log file, not to the screen.
version
listhba
screendisplay o=0
download a=lpe11000 i=c:\temp\zd272a2.all
listboot n=2
enableboot n=2 i=1
Updating Non-volatile WWNN (scriptwwnn)
This command reads the WWNN words 0 and 1 from the command line to update the
non-volatile WWNN. You can also include this command in a script file. When the
adapter is discovered, the new WWNN value is used. The adapter retains the original
WWNN in another region of the firmware.
Caution: Use the scriptwwnn command with caution. If you use the same WWNN on
more than one adapter in a fabric, unpredictable results may occur.
To change WWNN words 0 and 1 from the command line, type (all in one line)
oslpcfg scriptwwnn n= w0= w1=
The following example updates non-volatile WWNN word 0 and word 1 for adapter
#1:
oslpcfg scriptwwnn n=1 w0=10000345 w1=B620A1B2
Notes:

Word 0 of WWNN and WWPN names must follow one of the following
formats:
1 0 0 0 0 x x x
2 x x x x x x x
3 x x x x x x x
5 x x x x x x x

If the scriptvwwnn command has been used previously, the adapter continues
to use that WWNN until you change the WWNN with the restorenvwwn
command.
Updating Non-volatile WWPN (scriptwwpn)
This command reads WWPN words 0 and 1 from the command line to update the
non-volatile WWPN. You can also include this command in a script file. When it is
discovered, the adapter uses the new WWNN value. It does not use the original IEEE
address assigned by manufacturing (located in Configuration Region 16 or 32).
Caution: Use the scriptwwpn command with caution. If you use the same WWPN on
more than one adapter in a fabric, unpredictable results may occur.