Dell Emulex Family of Adapters - Manual (Page 360)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Diagnostic Commands
360
Base Address 0: 0x00000000 Base Address 1: 0xDF478000
Base Address 2: 0xDF480004 Base Address 3: 0x00000000
Base Address 4: 0xDF4A0004 Base Address 5: 0x00000000
CIS: 0x00000000 SubVendor ID: 0x10DF
SubSystem ID: 0xE622 ROM Base Address: 0x00000000
Interrupt Line: 0x00 Interrupt Pin: 0x01
Minimum Grant: 0x00 Maximum Latency: 0x00
Capabilities Ptr: 0x40
PostTest
Note: Not supported for OneConnect and LPe15000 or LPe16000 series adapters.
This command runs the POST on the adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
PostTest
Parameters
SetBeacon
This command turns the beacon on or off.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetBeacon
Parameters
WWPN
The WWPN of the FC port.
WWPN
The WWPN of an FC port.
MAC
The MAC address of a NIC or iSCSI port.
BeaconState
Indicates the state of the beacon to be set to value:
0 = Off
1 = On