Dell Emulex Family of Adapters - Manual (Page 150)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
150
The Host Driver Parameters Tab
The Host Driver Parameters tab enables you to view and edit the adapter driver
parameter settings contained in a specific host. The host driver parameters are global
values and apply to all adapters in that host unless they are overridden by parameters
assigned to a specific adapter using the adapter Driver Parameters tab. For each
parameter, the tab shows the current value, the range of acceptable values, the default
value, and whether the parameter is dynamic. A dynamic parameter allows the change
to take effect without resetting the adapter or rebooting the system.
For information on changing parameters for a single adapter, see “Setting Driver
Parameters” on page 151. For information on changing parameters for the host, see
“Setting Driver Parameters for All Adapters in a Host” on page 154.
Note: If there are no discovered FC or FCoE ports, the entire Host Driver Parameters
tab is grayed-out. This occurs because there are no drivers to which the host
driver parameters apply.
Figure 8-26 Host Driver Parameters Tab
Host Driver Parameters Tab Field Definitions

Installed Driver Type – The current drivers installed on this host. If there is
more than one driver type installed, the Installed Driver Types drop-down
menu shows a list of all driver types that are installed on the adapters in the
host and enables you to select the particular driver type to configure.

Adapter Parameter table – A list of adapter driver parameters for the selected
driver type and their current values.
Modify Adapter Parameter Area