Dell Emulex Family of Adapters - Manual (Page 421)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
421
Note: The protocols specified by the f0-fm parameters are the names displayed by the
ShowProperties command.
The following rules apply when using this command with non-NPar multichannel
enabled:

There must be no spaces before or after the “=” and commas (,) in the port
specification. For instance, “p0 = nic, iscsi” would cause an error.

The only choice for f0 is NIC or NIC+RoCE. Choices for f1 through fm are
“None”, iSCSI, FCoE or NIC. NIC for f1 through fm can only be specified for
multichannel configurations. Except for NPar, iSCSI and FCoE are limited to f1
and f2.

This command will fail under the following conditions:

Two storage protocols on a port are specified and concurrent storage mode
is not available.

Three storage protocols on a port are specified.

Two of the same storage protocols on a port are specified.

NIC+RoCE can only be specified as the f0 parameter with no other “f“
parameters specified and cannot be specified with multichannel configurations.
If NIC+RoCE is specified for any of the port functions, all other port function
specifications must be NIC or NIC+RoCE only. For example, a single NIC or
NIC+RoCE function per port is all that is allowed. Also, NIC+RoCE can only be
specified when mctype=none.
fcnCfg
ProfileID
This parameter is required when specifying a NIC only or NIC+RoCE
personality. Otherwise this parameter must be omitted.
Type
Optional multichannel type specification. This parameter is required to
enable multichannel. Specify “None” to disable multichannel. If you do
not specify an mctype, no change to the configured multichannel type is
made. For a list of supported mctypes, use the “CMGetParams”
command on page 342 and review the “Available Modes” field.
NParEpMode
NParEP Mode state (DELL Only). This parameter can only be specified
when mctype=NPar.
0=Disabled, 1=Enabled)
:: f0[,f1[,...fM]] where:
f0 1st function protocol on port (must be NIC or NIC+RoCE).
f1 2nd function protocol on port (optional).
fm Mth function protocol on port (optional). The number of
functions per port, the value of “M”, are model and
multichannel type specific.