Dell Emulex Family of Adapters - Manual (Page 707)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
NIC Error and Event Logs
707
0x0025/37 Warning The device firmware does not
support TCP offload functionality. The firmware and the driver are not
compatible versions. See the
Downloads section of the Emulex
website for compatible firmware
and drivers.
0x0024/36 Error The device firmware does not
support network functionality. The firmware and the driver are not
compatible versions. See the
Downloads section of the Emulex
website for compatible firmware
and drivers.
0x0023/35 Warning The Ethernet link is down due to a
remote fault. The Ethernet link is down due to the
remote partner signaling a fault.
Check the peer device for errors.
0x0022/34 Warning The Ethernet link is down due to a
local fault. The Ethernet link is down due to a
link-down event detected at the
driver.
0x0021/33 Informational Network device is operating in Gen2
mode and installed in a 4x PCIe slot. For best performance, install the
adapter in an 8x Gen2 PCIe slot.
Note: A 16x slot will not provide any
additional performance.
0x0020/32 Informational The network device is operating in
Gen2 mode and installed in a 1x
PCIe slot. For best performance, install the
adapter in an 8x Gen2 PCIe slot.
Note: A 16x slot will not provide any
additional performance.
0x001f/31 Informational The network device is operating in
Gen1 mode and installed in a 8x
PCIe slot. For best performance, install the
adapter in an 8x Gen2 PCIe slot.
Note: A 16x slot will not provide any
additional performance.
0x001e/30 Informational The network device is operating in
Gen1 mode and installed in a 4x
PCIe slot. For best performance, install the
adapter in an 8x Gen1 PCIe slot.
Note: A 16x slot will not provide any
additional performance.
0x001d/29 Informational The network device is operating in
Gen1 mode and installed in a 1x
PCIe slot. For best performance, install the
adapter in an 8x Gen1 PCIe slot.
Note: A 16x slot will not provide any
additional performance.
0x001c/28 Error Vital product data is not initialized
correctly. Use the offline flash utility to
reconfigure the device.
0x0015/21 Warning Firmware version does not match
driver version. The firmware version and driver
must match. This is a warning
message, but it is recommended
that you reinstall matching versions
of the firmware and driver.
Table A-13 NIC Event Log Entries (Continued)
Message ID
Hexadecimal/
Decimal Severity Message Recommended Resolution