Dell Emulex Family of Adapters - Manual (Page 196)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OneConnect Adapters
196

HW Version – The hardware version of the selected adapter.

NCSI Version – The Network Controller Sideband Interface version.

IPL File Name – The name of the IPL (Initial Program Load) file currently
loaded.

PCI Express Link Speed – The speed of the PCI bus in which the adapter
running.

PCI Express Bus Width – The number of lanes for the slot in which the adapter
is running.

Adapter Temperature – If the adapter's temperature is not available, “Not
Supported” is displayed. If supported by the adapter, this field displays the
adapter's temperature and one of the following temperature-related status
messages:

Normal: The adapter’s temperature is within normal operational range.

Warning: The adapter’s temperature is beyond normal operational range. If
the temperature continues to increase, the adapter shuts down. You must
determine the cause of the temperature problem and fix it immediately.
Check for system cooling issues. Common causes of system cooling issues
include clogged air filters, inoperable fans and air conditioning problems
that cause high ambient air temperatures.

Exceeds operational range: The temperature has reached critical limit. You
must determine the cause of the temperature problem and fix it before
resuming operation. Check for system cooling issues. Common causes of
system cooling issues include clogged air filters, inoperable fans and air
conditioning problems that cause high ambient air temperatures.
After the system overheating issue is resolved and the adapter has cooled
down, reboot the system or, if the system supports hot swapping, cycle the
power of the adapter slot.
Personality Area

Current – The current personality in use by the adapter.

After Reboot
Note: Not available on OneConnect OCe11101-EM/EX or OCe11102-EM/EX
adapters.

FCoE – Check to choose the FCoE personality.

iSCSI – Check to choose the iSCSI personality.

NIC Only – Check to choose the NIC only personality.
Note: Some of the personalities may be disabled if the personality is not
available on the adapter.

Apply button – Click to apply the personality you choose. The system must be
rebooted for your selection to take affect.