Dell Emulex Family of Adapters - Manual (Page 1775)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix F. Dell UEFI
Main Configuration Page
1775
iSCSI First Target Parameters Page
This page allows you to enable a connection for the first iSCSI target and configure
parameters.
Figure F-10 iSCSI First Target Parameters Page
CHAP ID Specify the initiator CHAP ID. The valid range is 0–128 characters in
length. If this can be set on a per target basis, then the first target
value must be stored here.
CHAP Secret Specify the ISCSI initiator’s CHAP Secret. The valid range is 0 or
12–16 characters in length. If this can be set on a per target basis,
the value for the first target must be stored here.
Table F-9 iSCSI First Target Parameters Page Menu Options
Menu Option Description and Available Settings
Connect Enable connecting to the first iSCSI target.
Available settings include:
• Enabled
• Disabled (default)
IP Address Specify the first target’s IP address. The value should be in either
IPv4 or IPv6 format and can be 2–39 characters long.
TCP Port Specify the first target’s TCP port number. The valid range is
1–65535.
Table F-8 iSCSI Initiator Parameters Page Menu Options (Continued)
Menu Option Description and Available Settings