Dell Emulex Family of Adapters - Manual (Page 1677)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
12. Configuring UEFI for iSCSI
Adding and Configuring Targets
1677
3. Reboot the system.
4. On the Controller Configuration menu (Figure 12-2), select iSCSI Target
Configuration and press . The iSCSI Target Configuration screen shows the
discovered targets.
Note: For more information on configuring a DHCP boot target, refer to
“Discovering Targets through DHCP for iSCSI” on page 1622.
Figure 12-13 iSCSI Target Configuration Screen
Using SendTargets Discovery to Add an iSCSI Target
SendTargets discovery asks an iSCSI target to provide the list of target names that can
be logged into by the initiator. The iSCSI initiator then uses the SendTargets Discovery
option to perform the device discovery. Use this method if an iSCSI node has a large
number of targets. When adding an iSCSI target, leave the iSCSI target name option
blank, you can use the iSCSI SendTargets mechanism to add a target.
To configure an iSCSI target using the SendTargets discovery:
1. On the Controller Properties screen (Figure 12-5), set Discover Boot Target via
DHCP to and press .
2. Select Save Changes and press .
3. Reboot the system.
4. From the Controller Configuration Menu screen (Figure 12-2), select iSCSI Target
Configuration and press .
5. Select Add Target and press .
6. In the Add/Ping iSCSI Target dialog box, leave the iSCSI Target Name blank for a
SendTargets response.