Dell Emulex Family of Adapters - Manual (Page 340)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Boot Commands
340
Boot Commands
EnableBootCode
This command is used to perform either of the following:

Enable or disable network boot for NIC ports. If network boot is being enabled,
it is necessary to select the specific network boot type. The supported network
boot types are PXE and iBFT. Note that iBFT is not supported on all NIC
adapter types.

Enable/disable the boot code for an FC adapter port. If the boot code is disabled
on the FC adapter, the adapter does not boot from the SAN, regardless of the
value for the EnableBootFromSan boot parameter. If the boot code is enabled on
the FC adapter, the adapter boots from the SAN if the EnableBootFromSan
parameter is also enabled.
Note: To enable or disable boot on an iSCSI target, see the “SetiSCSIBoot” command.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
EnableBootCode
Parameters
Examples
The following example enables iBFT for a NIC:
C:\Program Files\Emulex\Util\OCManager>HBACMD EnableNetworkBoot
00-00-c9-11-22-33 e iBFT
The following example disables network boot:
C:\Program Files\Emulex\Util\OCManager>HBACMD EnableNetworkBoot
00-00-c9-11-22-33 d
WWPN
The WWPN of an FC port.
NIC MAC
The MAC address of a NIC port.
Flag
D = Disable the boot code.
E = Enable the boot code.
NetworkBootMethod
Network boot method to be used by the NIC (“PXE” or “iBFT”.
The network boot types supported on the specific NIC may be
found in the Available Network Boot Methods string displayed
by the HbaAttributes command. This parameter is not required
for FC or FCoE ports, and is only specified when enabling
network boot.