Dell Emulex Family of Adapters - Manual (Page 892)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
892
0293: PM resume failed to start worker thread: error=
The PCI resume (hotplug) could not start the worker thread for the driver.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Unload and reload the driver.
0294: PM resume Failed to enable interrupt
The PCI resume (hotplug) could not get an interrupt vector.
Data: None
Severity: Error
Log:
LOG_INIT
Action: Unload and reload the driver.
0297: Invalid device group
While unloading the driver, the driver detect a PCI device that it should not have claimed.
Data: None
Severity: Error
Log:
LOG_INIT
Action: None required.
0299: Invalid SLI revision
While processing a host attention or unrecoverable error, the driver detected an invalid SLI revision.
Data: None
Severity: Error
Log:
LOG_INIT
Action: None required.
0300: LATT: Cannot issue READ_LA: Data:
The link attention handler could not issue a READ_LA mailbox command.
Data: None
Severity: Error
Log:
LOG_MBOX
Action: None required.
0301: READ_SPARAM: no buffers
The driver attempted to issue a READ_SPARAM mailbox command to the adapter, but there were no
buffers available.
Data: None
Severity: Warning
Log: LOG_MBOX
verbose
Action: This message indicates: (1) Kernel virtual memory is depleted. Check that the system
meets minimum RAM requirements for the Emulex FC adapter. Try closing other
applications to free some memory. (2) A possible driver buffer management issue. If this
issue persists, report the error to Technical Support.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)