Dell Emulex Family of Adapters - Manual (Page 580)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
3. Configuration
FC/FCoE Driver Configuration
580
Most parameters default to a setting that optimizes adapter performance.
Table 3-1 Storport Miniport Driver Parameters
Parameter Definitions
Activation
Requirement
Adapter/Protocol
AutoMap=n AutoMap controls the way targets are assigned
SCSI IDs. Discovered targets are assigned
persistent SCSI IDs according to the selected
binding method. Persistent bindings do not take
effect with the driver in stand-alone mode.
0 = automap is disabled. The OneCommand
Manager application persistently sets the SCSI
address of a discovered FCP capable FC node
(target).
1 = automap by WWNN.
2 = automap by WWPN.
3 = automap by DID
Value: 0–3
Default = 2 Reboot
Class=n Class selects the class of service on FCP
commands.
If set to 2, class = 2.
If set to 3, class = 3.
Value: 2–3
Default = 3 Dynamic FC Only
CoalesceMsCnt=n CoalesceMsCn specifies wait time in milliseconds
to generate an interrupt response if
CoalesceRspCnt has not been satisfied. Zero
specifies an immediate interrupt response
notification. A non-zero value enables response
coalescing at the specified interval in
milliseconds.
Value: 0–63 (decimal) or 0x0–0x3F (hex)
Default = 0 (0x0) Reset LightPulse Only
CoalesceRspCnt=n CoalesceRspCn specifies the number of response
entries that trigger an Interrupt response.
Value: 0–255 (decimal) or 0x1–0xFF (hex)
Default = 8 (0x8) Reset LightPulse Only