Dell Emulex Family of Adapters - Manual (Page 1611)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
10. Configuring and Managing iSCSI Targets with the iSCSISelect Utility
Adding iSCSI Targets
1611
Using SendTargets Discovery to Add an iSCSI Target
SendTargets discovery asks an iSCSI target to provide the list of target names that can
be logged into by the initiator. The iSCSI initiator then uses the SendTargets Discovery
option to perform the device discovery. Use this method if an iSCSI node has a large
number of targets. When adding an iSCSI target, leave the iSCSI target name option
blank, you can use the iSCSI SendTargets mechanism to add a target.
To configure an iSCSI target using the SendTargets discovery:
1. Log into the iSCSISelect utility by pressing when prompted.
2. Select Controller Configuration and press . A list of controllers is
displayed.
3. Select a controller and press . The Controller Configuration menu is
displayed.
Figure 10-1 Controller Configuration Menu
4. From the Controller Configuration menu, select iSCSI Target Configuration and
press .
5. Select Add New iSCSI Target and press .
6. In the Add/Ping iSCSI Target dialog box, leave the iSCSI Target Name blank for a
SendTargets response.
Note: Only the first 64 sessions are returned during a single discovery session.
Figure 10-2 Add/Ping iSCSI Target dialog box
7. Enter the iSCSI target IP address.
8. Change the TCP port number value, if necessary. The default target port number is
3260.
9. For a boot target, accept the default (No), even if you want to enable the target as a
boot target. For more information about the boot target, see “Setting Up a Basic