Dell Emulex Family of Adapters - Manual (Page 714)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
iSCSI Error and Event Log
714
0x04 Error Firmware version does not
match with driver version. The driver version that is running on the system
does not match the version of the firmware on
the UCNA. Install a driver that is compatible
with the firmware.
0x05 Warning Port link is down, check
connection to UCNA. Check the links to the UCNA.
0x06 Info Port link is up. N/A
0x07 Error Link down timeout expired on
the port, all targets are lost. The link on the UCNA is down for a period
exceeding the LDTO value. If the UCNA has a
connection to the target, event log entries from
the disk subsystem indicate that the drives
were lost. If any I/O was in progress, the
system may see I/O errors or failures.
Check the links to the UCNA. If the link is
reestablished, any sessions that previously
existed are reestablished and the devices are
available for I/O.
0x08 Error Target with session id N failed
to connect within the
configured timeout. A connection to the target was lost for a period
exceeding the ETO. The error log entry includes
the session ID of the target that lost the
connection. Event log entries from the disk
subsystem indicate that the drives were lost. If
any I/O was in progress, the system may see I/O
errors or failures.
Check the connection to the target or the state
of the target device. If the target is made
available, any sessions that previously existed
are reestablished and the devices are available
for I/O.
0x09 Error Task Management request N
was unhandled. The iSCSI driver received a Task Management
Function that is not supported, and it rejected
this request.
An application or service that is installed on the
system may not be compatible with the driver.
0x0a Error Task Management Function
abort was received on a task
that is not present. The iSCSI driver received a Task Management
Function Abort request for an I/O request that
is not present with the driver.
This may indicate a slow connection to the
target. Check network connectivity to the
target for any errors.
0x0b Error Error in determining firmware
configuration. An error in determining the firmware
configuration occurred. The firmware on the
UCNA may not be functioning properly. Check
the UCNA and reinstall the firmware if
required.
Table A-15 iSCSI Error Log Entries on Windows 7, Windows 8, Windows 8.1, Windows Server 2008 R2, Windows
Server 2012, and Windows Server 2012 R2 (Continued)
Message ID Severity Message Recommended Resolution