Dell Emulex Family of Adapters - Manual (Page 1016)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
3. Configuration
FC and FCoE Driver Configuration
1016
scan_down Start scanning for devices
from highest AL_PA to
lowest Def = 1
Min = 0
Max = 1 Def = 1
Min = 0
Max = 1 No changes
topology Select FC topology. Valid
values are:
0x0 = attempt loop
mode then
point-to-point
0x01 = internal loopback
mode
0x02 = attempt
point-to-point mode
only
0x04 = attempt loop
mode only
0x06 = attempt
point-to-point mode
then loop
Def = 0
Min = 0
Max = 6 Def = 0
Min = 0
Max = 6 No changes
link_speed Select link speed:
0 = auto select
1 = 1 Gigabaud
2 = 2 Gigabaud
4 = 4 Gigabaud
8 = 8 Gigabaud
10 = 10 Gigabaud
16 = 16 Gigabaud
Def = 0
Min = 0
Max = 16 Def = 0
Min = 0
Max = 16 No changes
fcp_class Select FC class of service
for FCP sequences Def = 3
Min = 2
Max = 3 Def = 3
Min = 2
Max = 3 No changes
use_adisc Use ADISC on rediscovery to
authenticate FCP devices,
instead of PLOGI. Def = 0
Min = 0
Max = 1 Def = 0
Min = 0
Max = 1 No changes
first_burst_size First burst size for targets
that support first burst.
Def = 0
Min = 0
Max = 65536 For the native mode
driver.
Table 3-1 FC and FCoE Driver Parameters (Continued)
Module
Parameter
Description
ESXi 5.0, 5.1
Legacy
Driver Model
Values ESXi 5.5 OP
Native Mode
Driver Model
Values
Comments