Dell Emulex Family of Adapters - Manual (Page 1160)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
1. Introduction
1160
1. Introduction
Emulex
®
OneCommand Manager
™
for VMware vCenter integrates the in-depth
management of Emulex host bus adapters (HBAs), universal converged network
adapters (UCNAs), and converged fabric adapters (CFAs) into the VMware vCenter
management console.
This comprehensive solution builds upon standard Emulex Common Interface Model
(CIM) management providers and advanced functionality delivered with the Emulex
OneCommand Manager application to present native configuration management,
status monitoring, and online maintenance of Emulex adapters in VMware ESXi
environments, using a graphical (GUI) or command line (CLI) user interface.
OneCommand Manager for VMware vCenter supports the following VMware
platforms:

VMware ESXi 5.5

VMware ESXi 5.1

VMware ESXi 5.0
OneCommand Manager for VMware vCenter can be hosted/registered on the
following servers:

vCenter Server 5.5

vCenter Server 5.1

vCenter Server 5.0
OneCommand Manager for VMware vCenter is supported for the following operating
systems:

Windows Server 2008 SP2 (or later) – Standard, Enterprise and Datacenter
editions (32 bit, x86) and (64 bit, x86_64)

Windows Server 2008 R2 – Standard, Enterprise and Datacenter editions (32 bit,
x86) and (64 bit, x86_64)

Windows 7 -x64

Windows 8 -x64

Windows 8.1 -x64

Windows Server 2012
Refer to Table 1-1, Support Provided by Emulex CIM Provider Versions, on page 18 to
determine the support provided by your Emulex CIM Provider.
Note: Screen shots in this manual are for illustrative purposes only. Your system
information can vary.
OneCommand Manager for VMware vCenter supports Emulex LPe16202 CFAs. If the
CFA is in Fibre Channel (FC) mode, it functions as an FC adapter. If it is in Fibre