Dell Emulex Family of Adapters - Manual (Page 1663)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
12. Configuring UEFI for iSCSI
Overview
1663
12. Configuring UEFI for iSCSI
Note: For systems with multiple adapters, the UEFI system firmware or boot code
uses the highest version driver installed on any of the adapters. Adapters with
older versions of EFIBoot are managed by the more recent version, but only as
long as the adapter with the most recent version is in the system. The latest
firmware and boot code must be installed on each adapter in the system to
ensure that each adapter runs the latest firmware and boot code.
Overview
UEFIBoot supports:

EFI protocols – Configuration and component name are supported.

Operating systems – Windows Server 2008 R2, Windows Server 2012, Windows
Server 2012 R2, RHEL 6.x and newer, and SLES 11 SP2 and newer

Multi-Device path – SCSI device path is selectable through the driver
configuration protocol.

Multi-initiators – Up to 96 adapters in a system.

Multi-target – 256 targets are selectable through the driver configuration
protocol.

Multi-LUNs – Up to 256 LUNs are supported.

Multi-utility – Setup is supported.
This version of UEFIboot is loaded from flash into system memory.
When UEFIBoot is loaded in an EFI Shell, type “
drivers
” and press to see if
the driver is loaded.
Note: If you are using Dell adapters, refer to appendix F., “Dell UEFI,” on page 1762
for information on using the Dell UEFI utility.
Navigating the Emulex iSCSI Configuration Utility
The Emulex iSCSI configuration utility has menus and configuration screens. Use the
following methods to navigate them:

Press the up/down arrows on your keyboard to navigate menu options or
configuration fields. When multiple adapters are listed, use the up/down
arrows to scroll to the additional adapters.

Press the <+>, <->, or keys to change numeric values.

Press to select an option.

Press to exit the current screen and show the previous screen.