Dell Emulex Family of Adapters - Manual (Page 1065)

Emulex Drivers Version 10.2 for VMware ESXi User Manual P010087-01A Rev. A
4. Troubleshooting
Troubleshooting the FC/FCoE Driver
1065
elx_mes0425: lpfc_"#attr" attribute cannot be set to , allowed
range is [min, max]
DESCRIPTION: Driver attribute lpfc_#attr was defined with an out-of-range value.
DATA: None
ACTION: Set the parameter between the minimum and maximum value.
elx_mes0426: lpfc_enable_auth attribute cannot be set to ,
allowed range is [, ]
DESCRIPTION:
DATA: None
ACTION: None required.
elx_mes0427: Cannot re-enable interrupt after slot reset.
DESCRIPTION: The driver was not able to enable the interrupt after an adapter reset.
DATA: None
ACTION: Unload and reload the driver.
elx_mes0430: PM resume Failed to enable interrupt
DESCRIPTION: The driver’s power management resume function could not enable the
interrupt.
DATA: None
ACTION: Perform another PM suspend and resume or adapter reset.
elx_mes0431: Failed to enable interrupt.
DESCRIPTION: The driver failed to start the interrupt.
DATA: None
ACTION: Unload and reload the driver.
elx_mes0433: Wakeup on signal: rc=
DESCRIPTION: A signal other than the LPFC_DATA_READY was received on the
worker thread.
DATA: None
ACTION: Unload and reload the driver.
elx_mes0434: PM resume failed to start worker thread: error=.
DESCRIPTION: The driver's power management resume function could not start the
worker thread.
DATA: None
ACTION: Unload and reload the driver.