D chapter 4., “offline – Dell Emulex Family of Adapters User Manual
Page 484
Offline and Online Adapter Management Utilities Version 10.2 User Manual
P010071-01A Rev. A
4. Offline Adapter Management Utility Command Line Interface
Running the Offline Adapter Management Utility from the Command Prompt
484
4. Offline Adapter Management Utility
Command Line Interface
The Offline Adapter Management Utility allows you to configure Emulex adapters
before you install or boot a server operating system.
The Offline Adapter Management Utility includes:
winlpcfg
linlpcfg
You can use the Offline Adapter Management Utility to do the following:
View information on an Emulex adapter
Reset the adapter
Download firmware and boot code files
Select a boot device
Read and update WWNs
Enable boot code
Update configuration regions
Set the adapter to use soft jumpers
Run diagnostic tests
Read and process script files
Running the Offline Adapter Management Utility
from the Command Prompt
Note: You must start the WinPE and Linux Offline Adapter Management Utility at the
command prompt.
1. Boot the system with a supported operating system.
2. Start the Offline Adapter Management Utility with a valid command or a valid
script file name.
To start an Offline Adapter Management Utility from the command line, move
to the directory where the executable file resides and type
oslpcfg
For example, starting the WinPE Offline Adapter Management Utility with
a reset command:
winlpcfg reset n=2
For example, starting the Linux Offline Adapter Management Utility with a
reset command:
./linlpcfg reset n=2
To start an Offline Adapter Management Utility with a script file name, from
the directory where the oslpcfg.exe file resides, type
oslpcfg @