Dell Emulex Family of Adapters - Manual (Page 1642)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
11. Configuring UEFI for Ethernet
Starting the Emulex NIC Configuration Utility
1642
To configure SR-IOV:
1. On the Controller Configuration screen, select Configure SRIOV and press
. The Configure SRIOV screen appears.
Figure 11-12 Configure SRIOV Screen
2. Select the current setting for a particular NIC function and a pop-up menu appears.
3. Select Enable or Disable and press .
4. When you are finished, press to return to the Controller Configuration
screen.
For more information on SR-IOV configuration, see the appropriate Emulex driver
manual.
Configuring NIC Mode
Note: This setting is only available when SR-IOV is enabled, the Personality Selection
is set to “NIC”, and a two-port OCe14000-series adapter is in use.
This setting allows you to control the VF count on a two-port OCe14000-series adapter.
The choices include:

NIC Only Profile – the VF count is restricted to 31 VFs per port and QoS is
supported for those VFs.

NIC-ETS Disabled – the VF count is set to 63 VFs per port but QoS is not
supported for those VFs.