Dell Emulex Family of Adapters - Manual (Page 422)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
422

The number of functions (f) specified depends upon the adapter model and
configuration type, for example, non-multichannel, multichannel, RoCE, and
NPar. If an incorrect number of functions are specified, an error is generated.

The pid=ProfileID option is required for NIC+RoCE configurations. If it
specified and the profile does not work with the specified port functions, an
error is generated.

f0 must always be specified. However if the rest of the functions on a port can be
set to "None", they do not need to be specified. For example, p0=NIC,iSCSI
p1=NIC,None could be specified as p0=NIC,iSCSI p1=NIC.

Storage protocols can be configured on f1 and/or f2, however, you must be
aware of whether you are configuring in “concurrent mode” or “mixed mode.”

If you are configuring storage protocols in “concurrent mode,” f1 and f2
cannot be assigned the same storage protocol.

If you are configuring storage protocols in “mixed mode,” only f1 or f2 can
be assigned a storage protocol, but not both.

If mctype is specified, it must be an available multichannel type or set to
“None” to disable multichannel. If not specified, the currently configured
multichannel type (including “None”) remains unchanged. See
“CMGetParams” command on page 342 for available multichannel types.

If the functions being set to "None" are the last function(s) on a port, they do not
need to be specified. For example, p0=nic,iscsi,none can be shortened to
p0=nic,iscsi.

NParEP Mode can only be specified when the mctype= parameter is set to NPar
or when the currently configured multichannel type is NPar.

When disabling NPar, that is mctype=none, NParEP Mode is automatically
disabled.

A reboot is required to activate the new port configuration.
Examples
Mixed Mode
>hbacmd SetAdapterPortConfig 00-00-c9-12-34-56 p0=nic,iscsi
p1=nic,fcoe p2=nic,fcoe p3=nic
>hbacmd GetAdapterPortConfig 00-00-c9-12-34-56
Number of Ports : 4
Maximum FCoE Functions : 4
Maximum iSCSI Functions : 4
Mixed Mode I/O Allowed : Yes
Concurrent Mode I/O Allowed : No
ROCE Functions Allowed : Yes
RebootRequired : Yes
Active Configuration