Dell Emulex Family of Adapters - Manual (Page 350)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
DCB Commands
350
SetDCBParam
This command configures the DCB and LLDP settings on a OneConnect adapter port.
Use the GetDCBParams command to obtain valid parameter names for use in this
command.
Notes:

You cannot set DCBX mode. If you attempt to specify a “dcbxmode” parameter,
an error message is displayed.

RoCE is only available on the OCe140000-series of adapters.

RoCE is only available on Windows operating systems.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetDCBParam
Parameters
DCB Settings for and
WWPN
The WWPN of an FCoE port.
MAC
The MAC address of a NIC or iSCSI port.
Param
The parameter name. See the following “DCB Settings for and
” and “LLDP Settings for and ” sections.
Value
The parameter value. See the following “DCB Settings for and
” and “LLDP Settings for and ” sections.
Description and
DCBXState
The DCBX protocol state.
0 = Disabled
1 = Enabled
PFCEnable
Flow control in both directions (transmit and receive).
0 = Disabled
1 = Enabled
FCoEPriority
This parameter is applicable for ports running FCoE only. A
single priority must be specified. The range of valid values is 0-7.
Note: Only one priority can be specified for each invocation of this command
and must be for a protocol running on the port. If more than one
protocol priority can be set, they should be unique values.
iSCSIPriority
This parameter is applicable for ports running iSCSI only. A
single priority must be specified. The range of valid values is 0-7.
Note: Only one priority can be specified for each invocation of this command
and must be for a protocol running on the port. If more than one
protocol priority can be set, they should be unique values.