Loading default settings – Dell Emulex Family of Adapters User Manual

Page 1549

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual

P010097-01B Rev. A

3. Configuring PXE Boot for NIC on OCe14000-series Adapters

Using the PXESelect Utility

1549

To select the personality of the adapter:
1. From the Configure Controller screen (Figure 3-12), use the up or down arrow keys

to select Personality.

2. Use the left or right arrow keys to select the desired personality.
3. Press to save.

Note: Changing the Personality setting requires a reboot before the change will

take effect. A reboot will occur when you exit the PXESelect utility if the

Personality setting has changed since the last boot.

Configuring the Custom Personality Selection

The Custom personality allows you to select the protocol type for each function. The

first function on the port must always be assigned the NIC personality. iSCSI and FCoE

personalities may only be enabled on one function per adapter port.

Note: There cannot be two iSCSI functions and two FCoE functions on a single port.

To select the Custom personality:
1. From the Configure Controller screen, use the up or down arrow keys to select

Personality.

2. Use the left or right arrow keys to select the Custom personality and press .

A pop-up menu is displayed.

3. Select the desired personality for the appropriate function using the arrow keys.

As mentioned previously for the Custom personality, iSCSI and FCoE personalities

may only be enabled on one function per adapter port.

4. Press to save.

Note: Changing the Personality setting requires a reboot before the change will

take effect. A reboot will occur when you exit the PXESelect utility if the

Personality setting has changed since the last boot.

Loading Default Settings

If you want to erase the current configuration, from the Configure Controller screen,