Dell Emulex Family of Adapters User Manual
Page 930
Emulex Drivers Version 10.2 for Linux User Manual
P010081-01A Rev. A
4. Troubleshooting
Log Messages
930
1302: Invalid speed for this board: Reset link speed to auto:
The driver is re-initializing the link speed to auto-detect.
Data:
None
Severity: Warning
Log:
LOG_LINK_EVENT verbose
Action:
None required.
1303: Link Up Event
A link up event was received. It is possible for multiple link events to be received together.
Data:
(1) fc_eventTag (2) granted_AL_PA (3) UlnkSpeed (4) alpa_map[0]
Detail:
If link events received, log (1) last event number received, (2) ALPA granted, (3) Link
speed (4) number of entries in the loop init LILP ALPA map. An ALPA map message is also
recorded if LINK_EVENT verbose mode is set. Each ALPA map message contains 16
AL_PAs.
Severity: Error
Log:
Always
Action:
If numerous link events are occurring, check the physical connections to the FC network.
1304: Link Up Event ALPA map
A link up event was received.
Data:
(1) wd1, (2) wd2, (3) wd3, (4) wd4
Severity: Warning
Log:
LOG_LINK_EVENT verbose
Action:
If numerous link events are occurring, check the physical connections to the FC network.
1305: Link Down Event
A link down event was received.
Data:
(1) fc_eventTag (2) hba_state (3) fc_flag
Severity: Error
Log:
Always
Action:
If numerous link events are occurring, check the physical connections to the FC network.
1306: Link Up Event in loop back mode x%x received Data: x%x x%x x%x x%x
Link up notification; configured for loopback.
Data:
(1) fc_eventTag (2) granted_AL_PA (3) UlnkSpeed (4) alpa_map[0]
Severity: Error
Log:
LOG_LINK_EVENT
Action:
None required.
1308: Menlo Maint Mode Link up Event x%x rcvd Data: x%x x%x x%x
Link down notification; configured for loopback.
Data:
(1) fc_eventTag (2) port_state (3) vport fc_flag
Severity: Error
Log:
LOG_LINK_EVENT
Action:
None required.
1309: Link Up Event npiv not supported in loop topology
NPIV is not supported in loop topology.
Data:
None
Severity: Error
Log:
LOG_LINK_EVENT
Action:
None required.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)