Dell Emulex Family of Adapters - Manual (Page 166)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
iSCSI
166

VLAN ID – The VLAN identifier to use 0-4094 (only valid when VLAN is
enabled). 0 indicates the VLAN is disabled.

VLAN Priority – The VLAN priority for the iSCSI interface.
IPV6 Address (OCe14000-Series Adapters only)

Automatic assignment – When enabled, the unique routable addresses are
assigned in conjunction with the router (similar for DHCP assignment).

Link Local Address – The unique address assigned to the port which is
available for use inside the local network but not outside of the local network.

Routable Address 1 – A routable address assigned to the iSCSI port.

Routable Address 2 – A second routable address assigned to the iSCSI port.

Gateway Address – The iSCSI initiator gateway address.
General area

Enable iSCSI Boot checkbox - Check or uncheck this box to enable or disable
iSCSI boot on the port.
Network Information Buttons (Not available in read-only mode.)

Advanced – Click to display the TCP/IP Configuration dialog box. See
“Advanced TCP/IP Configuration” on page 167 for more information.

Apply – Click to make and save your changes.
Modifying Port Settings
Note: Checking DHCP Enabled to automatically obtain an IP address disables the IP
address and subnet mask fields.
Note: If you enable both VLAN and DHCP, you must have a VLAN enabled DHCP
server to receive a valid IP address. In many cases the request to the DHCP
server for an IP address fails.
To modify TCP/IP configurations for iSCSI ports:
1. From the discovery-tree, select the iSCSI port whose configuration you want to
modify.
2. Select the Network Information tab.
3. Make your selections.
4. Click Apply.