Dell Emulex Family of Adapters - Manual (Page 383)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
383
Parameters
RemoveTargetPortal
This command removes the SendTarget Portal containing the IPv4 or IPv6 target IP
and the port from the list of portals for the specified initiator.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
RemoveTargetPortal
Parameters
SetBootTargetSession
This command enables and disables a iSCSI target’s session as a boot session. If a
session is enabled as a boot session and the system reboots, it attempts to boot from that
target.
Depending on whether the target is logged in, there are two different ways to specify
the session. If the target is logged in, use the parameter. If the target is not
logged in, use the parameter. You can specify an IPv4 or IPv6
target IP address.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetBootTargetSession
Target_IP>> <0|1>
Parameters
MAC_Address
The MAC address of an iSCSI port.
iscsi_target_name
Target’s iSCSI name enclosed in quotes. The string length is
11–255.
MAC_Address
The MAC address of an iSCSI port.
Target_IP
The target’s IP address. You can specify an IPv4 or IPv6 target IP
address.
Port
The port number of the target portal. The possible values are
1024–65535.
MAC_Address
The MAC address of an iSCSI port.
Target
Specifies the iSCSI name of the desired iSCSI target.