Dell Emulex Family of Adapters - Manual (Page 1595)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
7. Updating and Enabling Boot Code
1595
7. Updating and Enabling Boot Code
Emulex provides utilities to update and enable boot code. The utility that you use
depends on the operating system and, in some cases, the driver type or system
architecture. Table 7-1 indicates the utilities that are currently available for each
operating system.
After you decide which utility to use, see the appropriate documentation for the proper
procedures:

OneCommand Manager application: see the OneCommand Manager Application
User Manual, the OneCommand Manager Command Line Interface User Manual, or
the OneCommand Manager for VMware vCenter User Manual.

OCM CLI: see the OneCommand Manager Application CLI User Manual.

Offline utilities: see the Offline and Online Adapter Management Utilities User
Manual.

EFI utilities: see

chapter 11., “Configuring UEFI for Ethernet,” on page 1625

chapter 12., “Configuring UEFI for iSCSI,” on page 1663

chapter 13., “Configuring UEFI for FCoE,” on page 1693

OCM for VMware vCenter: see the OneCommand Manager for VMware vCenter
User Manual.
Table 7-1 Utilities that Update and Enable Boot Code
Operating
System OneCommand
Manager Application OCM CLI
Offline
Utilities EFI Utilities
OCM for
VMware
vCenter
Windows    
Linux 1    
VMware 2   
Solaris  
1) For the Citrix operating systems, the OneCommand Manager application CLI is not supported
locally, but can be managed using a remote system. The OneCommand Manager GUI application
is not supported.
2) For VMware operating systems, the OneCommand Manager application GUI and CLI are not
supported locally, but can be managed remotely using a Windows system.