Dell Emulex Family of Adapters User Manual
Page 413
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
Personality Change Commands
413
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
ChangePersonality
Parameters
Example
For non-ESXi hosts changing to FCoE personality:
hbacmd ChangePersonality 00-12-34-56-78-9A fcoe
For ESXi hosts changing to FCoE personality:
hbacmd changepersonality 00-00-c9-12-34-56 fcoe
Changing to NIC + RoCE personality with Profile ID 21:
hbacmd ChangePersonality 00-00-c9-12-34-56 nic+roce 21
hbacmd ShowPersonalities 00-00-c9-12-34-56
Adapter Personalities:
NIC
NIC+RoCE (configured)
iSCSI
FCoE (active)
WWPN
The WWPN of an FCoE port.
MAC
The MAC address of a NIC, NIC/RoCE, or iSCSI port.
type
The personality type to which the adapter is being changed. The
available values are shown when using the “ShowPersonalities”
command. See “ShowPersonalities” on page 414.
Profile_ID
Optionally specifies the profile ID number to used to identify
the personality. This number can be obtained from the
“ListProfiles”command on page 418 by looking at the “Active
Profile ID” field.
Notes:
• Profile_ID is required when specifying a NIC or NIC+RoCE personality. For
all other personalities, Profile_ID should not be specified.
• Selecting a profile that cannot be used with the specified personality
results in an error.