Dell Emulex Family of Adapters - Manual (Page 1382)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1382
Note: The PFC Throttle state is returned by the PortAttributes command for UCNAs.
However for UCNAs with older firmware that does not support PfcThrottle
and for FC adapters, the PFC Throttle state is not returned by the PortAttributes
command.
Parameters
setphyportspeed
Syntax
elxvcpcmd.exe v= u= p=
h= SetPhyPortSpeed [Speed [Length]]
Description
This command sets the port speed on OCe11102 adapters.
Parameters
Note: When Mode = 0, the Speed and Length arguments are ignored. When Mode = 1,
the Length arguments is ignored.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of a port on the ESXi host with Emulex adapters.
Flag
0 = Disabled
1 = Enabled
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
The WWPN of the FCoE port.
MAC
The MAC address of the UCNA port.
Mode
Mode number:
0 = Default
1 = Auto-Negotiate
2 = Force
Speed
Speed string that is required for Mode = 1 or 2 (s=10Gb/1Gb/100Mb).
Length
DAC cable length in meters (0-10, required for 10Gb SFP Plus
interface type).